How to Move Brush Size Bar in Procreate
StyleFrame Team7 min read
To move the brush size bar in Procreate, swipe inward from the left edge of the screen across the square Modify button until the sidebar pulls free of the edge. Keep your finger down, then slide the sidebar up or down to where you want it. To put it on the right side, open Actions (wrench icon) > Prefs and toggle Right-hand interface.
Step-by-Step: Moving the Brush Size and Opacity Sidebar
The brush size slider is the top slider of the left sidebar, with the opacity slider below it. The Modify button sits between them. Moving the sidebar is a single gesture, but it isn't obvious because there's no visible handle.
- Start at the very edge of the display. Place your finger on the bezel, or right at the screen edge next to the Modify button, not in the middle of the button.
- Swipe inward across the Modify button. Drag toward the canvas so the sidebar slides out of its docked position.
- Keep your finger on the glass. Once the sidebar detaches, it follows your finger as long as you don't lift.
- Slide up or down. Position it where your free hand rests naturally, then release.
The sidebar only moves vertically along the edge. You can't float it into the middle of the canvas, but you can choose which edge it lives on.
Why the Gesture Sometimes Doesn't Work
If you're swiping and nothing happens, it's usually one of a few causes. The gesture is finicky, and users report it working inconsistently until they adjust their technique.
You're starting too far inside the screen
A swipe that begins on top of the Modify button tends to trigger the eyedropper instead of dragging the sidebar. Begin your swipe outside the visible screen area, on the bezel, and move across the edge. It works like pulling up the iOS dock from the bottom: the gesture is recognized when your finger enters from outside the display.
Your case is blocking the edge
A case that sits close to the screen edge makes it harder to start the swipe from outside the display. If you've tried repeatedly and failed, try removing the iPad from its case or folding the case away from the left edge. For some users this was the entire problem.
You're lifting your finger too soon
The sidebar can pop out a short distance and then stay attached only while your finger remains on the screen. Use a quick, deliberate swipe, then hold and slide. If you lift immediately after the pop-out, you may think the gesture failed.
The interface is stuck
If the sidebar stops responding to every attempt, restart the iPad. Users who reported a "locked" sidebar were pointed to a hard reboot, which is the first thing to try before anything more drastic. Reinstalling the app shouldn't be necessary, and it's a risk if you have unsynced work.
Moving the Sidebar to the Right Side
Dragging the sidebar vertically doesn't change which edge it sits on. For that, use a preference:
- Tap Actions (the wrench icon, top left).
- Open Prefs.
- Toggle Right-hand interface.
This is the setting to use if you're left-handed, or if you hold the iPad in a way that puts the right edge nearer your off-hand. After flipping it, you can still drag the sidebar up or down using the same edge swipe, now from the right side.
Getting More Out of the Sliders Once They're in Place
Positioning the bar is only half the ergonomics. Procreate's sliders have a couple of behaviors that make them more precise than they look.
- Jump to a value: On the brush size slider, tap anywhere along the slider to jump straight to that point. This is useful for big changes, such as going from a fine liner to a broad texture brush.
- Fine adjustment: Press and hold the slider, then drag your finger sideways away from it, and without lifting, move up or down. The slider now changes in smaller increments, so you can dial in an exact size.
- Opacity works the same way for fine adjustment: The bottom slider uses the same sideways-drag precision behavior.
The sideways-drag trick matters most when you're matching line weights across a set of drawings, for example when sketching consistent storyboard panels or tracing keyframes for a cel animation.
Other Sidebar Controls Worth Knowing
The sidebar holds more than the two sliders, and moving it relocates all of them together.
- Modify button: Tap it to open the eyedropper, then slide over a color and release to sample. Hold it and tap anywhere on the canvas to sample without opening the full tool. You can also reprogram it to trigger other tools through Gesture Controls, which makes it a customizable shortcut.
- Undo and Redo arrows: Tap the top arrow to undo and the bottom arrow to redo. Tap and hold either to step through multiple actions quickly. Procreate supports up to 250 undo steps and shows a notification at the top of the interface telling you which action was affected.
A Practical Layout for Pencil-First Work
For most right-handed artists using an Apple Pencil, the default left-side sidebar is the right choice, since your left hand can reach the sliders without crossing your drawing hand. Place the sidebar around the vertical middle of the screen, or slightly lower if you rest your palm near the bottom of the iPad. That keeps the brush size slider within thumb range while the other fingers stay anchored on the bezel.
If you work with the iPad propped on a stand or Cintiq-like mount, move the sidebar up so it clears your wrist. Lefties should flip to Right-hand interface rather than reaching across the canvas.
Where Procreate Fits in a Motion Pipeline
Many motion designers, animators, and VFX artists use Procreate as a fast sketchbook: storyboards, style frames, character turnarounds, hand-painted textures, and matte-style paintovers. Tuning the interface so brush size is quick to reach is a small change that adds up across hundreds of strokes.
What comes next is where it gets more complicated. A Procreate painting is a still. To get it into motion, you typically export your artwork and rebuild it in a compositing or 3D tool, separating layers for parallax, rigging, or compositing. That's reliable but labor-intensive when you only need to explore how a style behaves in motion before committing.
Quick Troubleshooting Checklist
- Eyedropper appears instead of the sidebar moving: Your swipe began on the button. Start from the bezel instead.
- Works once in a while: Use a faster initial swipe, then keep your finger down while sliding.
- Case in the way: Remove or fold back the case, or start the swipe from outside the display.
- Completely unresponsive: Hard reboot the iPad and try again.
- Wrong side of the screen: Actions > Prefs > Right-hand interface.
- Slider too jumpy: Hold the slider and drag sideways before moving up or down for finer steps.
FAQ
Can I move the brush size bar anywhere on the canvas?
No. You can slide it up and down along its edge, and switch it between the left and right edges using the Right-hand interface preference. You can't float it freely over the canvas.
Why does the Modify button open the eyedropper when I try to drag it?
A tap or press that begins on the button is read as an eyedropper action. Start your swipe from outside the screen edge so Procreate registers a drag of the sidebar.
Do I need to update Procreate to move the sidebar?
The method of moving the sidebar changed when the Modify button was added. If you're following an older tutorial that describes tapping a specific spot, use the edge-swipe method above instead.
Does repositioning the sidebar affect my brush settings?
No. It only changes where the sliders, Modify button, and Undo/Redo arrows sit on screen. Your brush size, opacity, and other settings stay as they were.
Once the sidebar sits where your hand expects it, brush size becomes something you adjust without looking, and that is the whole point of the move.