How to Get Rid of the Side Bar on Procreate
StyleFrame Team7 min read
Procreate doesn't let you delete the sidebar, but you can move it or hide the whole interface. To move it, drag the square Modify button inward from the screen edge to pull the sidebar out, then slide it up or down. To put it on the other side of the canvas, go to Actions (wrench icon) > Prefs and turn on Right-hand interface. For a completely clean canvas, use Procreate's full-screen gesture (check Gesture Controls to see how it's assigned in your version) to hide all interface elements, including the sidebar.
What the Procreate Sidebar Actually Does
The sidebar is the slim vertical control strip on the left of the canvas. It holds four things:
- A brush size slider (top)
- The square Modify button (middle), which brings up the Eyedropper by default
- A brush opacity slider (bottom)
- Undo and Redo arrows
Procreate treats it as part of the core interface rather than an optional panel. We found no toggle in Prefs that removes it while leaving the rest of the UI visible. Most "get rid of it" problems come down to one of three situations:
- The sidebar is in the wrong place (bottom left, or on the wrong side).
- It's covering part of your canvas or crowding your hand while you work.
- You want a distraction-free view for reviewing, screen recording, or presenting.
Each has a different fix, covered below.
Method 1: Drag the Sidebar Out and Reposition It
If the sidebar has drifted to an awkward spot, such as the bottom corner after an accidental swipe, you can pull it back.
- Put your finger just outside the screen edge, or right at the edge next to the Modify button.
- Swipe inward across the Modify button, away from the edge.
- Keep your finger on the screen. The sidebar lifts out of its slot.
- Slide it up or down to where you want it, then release.
Two details make this work more reliably:
- Start the swipe off the screen. Beginning on the Modify button itself often just triggers the Eyedropper. Starting beyond the bezel and sliding in is the most consistent approach.
- Be quick, then hold. A fast initial swipe pops the sidebar loose. Keep your finger down afterward, because lifting it too early drops the sidebar back into place.
The Procreate Folio community has a long thread of people who found this gesture changed when the Modify button was introduced. Before that, you tapped a different spot to reposition it. If an older tutorial doesn't match what you see, that's why.
Method 2: Move the Sidebar to the Other Side
If the sidebar sits under your drawing hand, or you're left-handed, moving it to the opposite side is usually better than trying to hide it.
- Tap Actions (the wrench icon) in the top-left menu.
- Open Prefs.
- Toggle Right-hand interface.
The sidebar jumps to the right side of the canvas. Toggling again returns it to the default left position.
While you're in Prefs, you can also switch between Dark and Light interface modes. Dark is the more unobtrusive of the two, which helps if the goal is simply to keep the UI from drawing your eye.
Method 3: Hide the Whole Interface for a Clean Canvas
When you want the sidebar gone entirely, even temporarily, hide the full interface instead of the sidebar alone.
- Use the full-screen gesture to toggle the interface off and on.
- If the gesture does nothing, open Actions > Prefs > Gesture Controls and check how the gesture is assigned. Gesture mappings are customizable, so a previous setup may have changed or removed it.
- If you have a second display or AirPlay target, turn on Project Canvas in Prefs. The second screen shows only the canvas, full-screen, with no interface, zoom, or interruptions. Your iPad keeps its sidebar and tools while your audience or your own reference monitor sees a clean image.
Project Canvas is a good fit for client reviews and screen recordings. You keep your controls, and the viewer never sees UI.
Method 4: Reduce What the Sidebar Does Without Removing It
Sometimes the real complaint isn't the sidebar's presence. It's that you keep hitting it. A few adjustments help:
- Reprogram the Modify button. By default it triggers the Eyedropper, but it can be reassigned to other tools through Gesture Controls. If you never use it for color picking, you can give it a shortcut you do use.
- Use the sliders with finer control. Hold a slider and drag sideways, then up or down without lifting your finger. This gives smaller increments, so you don't need to nudge the sliders back and forth.
- Rely on gestures where you can. Undo can also be done with gestures, such as the two-finger hold for Rapid Undo, so you can stop reaching for the arrows. Undo supports up to 250 actions.
- Use the right-hand interface so your non-drawing hand naturally rests near the sidebar controls.
Troubleshooting: The Sidebar Won't Move
If you follow the steps above and nothing happens, work through these causes in order:
- Your iPad case is in the way. A case lip near the screen edge makes it hard to start the swipe outside the display. Remove the case, or angle your finger over the lip, and try again. One user in the Procreate community fixed their problem just by moving the case.
- You're starting on the Modify button. Start the swipe from beyond the edge of the screen, not on the button.
- You're lifting your finger too soon. Keep contact until the sidebar is in its new position.
- The gesture works only intermittently. Users have reported success rates that vary from attempt to attempt. When that happens, start further off-screen and swipe a bit faster.
- It seems completely locked. Restart the iPad. Procreate staff have suggested a hard reboot for this.
- It's on the wrong side. Check Right-hand interface in Prefs before assuming it's stuck.
A Note on Procreate Pocket
Procreate Pocket on iPhone may have a different layout from the iPad app, so the iPad steps above may not map exactly. The Prefs menu and the gesture controls are still the first places to check, but confirm the options in your own version.
Why Motion Designers Care About a Clean Procreate Canvas
For a motion or VFX artist, Procreate is rarely the final destination. It's often where you paint styleframes, concept art, matte elements, textures, or hand-drawn frames before they move to After Effects, Nuke, Blender, or Cinema 4D. A clean, uncluttered canvas matters in those cases for a few reasons:
- Screen recordings and review captures look better without UI, especially if you're sharing process clips or walking a director through a painted frame.
- Reference stills are easier to evaluate when no controls cover the edges of your composition.
- Export hygiene is simpler when you work in a consistent, predictable layout.
Hiding the interface before you present or capture means fewer re-takes and no cropping out of UI.
Taking Procreate Frames Into Motion
If you paint your keyframes or style references in Procreate, the next question is how to bring them into a moving pipeline without redrawing every frame. That's where can fit as a companion to your painting and compositing tools.
A practical workflow looks like this:
- Paint your keyframes in Procreate with the interface hidden so you can judge the composition at full size, and export them as images.
- Use them as reference inputs in Styleframe, so the frames you painted guide the look and motion of the result.
- Bring it back into your compositing app so the result slots into your existing pipeline like any other plate or element.
Your Procreate paintings stay the creative source, and your compositing workflow stays in the tools you already trust.
Quick Reference
Final Thoughts
Procreate keeps the sidebar as a permanent part of its layout, so "getting rid of it" really means relocating it, flipping it to the other hand, or hiding the entire interface. Learn the off-screen swipe, keep Right-hand interface in mind, and know your full-screen gesture, and you can handle nearly every situation. Once your canvas is clean and your frames are ready, you can carry them into a motion pipeline with the same level of control you used to paint them.