How to Draw Anime Eyes Procreate
StyleFrame Team8 min read
To draw anime eyes in Procreate, start with a face guide on a sketch layer, build the eye from a thick upper lash line, a large oval iris, a pupil, and one or two highlights, then separate each part onto its own layer. Shade the iris with a top-down gradient, add a lower lash line and brow, and finish with clean line art on a new layer. Layer discipline matters more than any single brush. If you plan to animate the eye later in After Effects or another tool, separate layers are what make a blink or a glance possible.
Set Up Procreate Before You Draw
A few minutes of setup saves redrawing later.
- Canvas: Create a canvas large enough to zoom into without softness. If the art is headed for a 1920×1080 or 4K comp, work at or above the final size, because scaling raster art up in compositing costs you edge quality.
- Color profile: Check that the canvas profile matches your pipeline. Color shifts when the art lands in a comp are worth testing once up front.
- Brushes: You need only three: a hard-edged inking brush (a technical-pen style brush or similar), a soft airbrush for gradients, and a textured or standard round brush for flat color. Anime eyes depend on crisp edges and clean gradients, not elaborate textures.
- Drawing Guide and Symmetry: Turn on a 2D grid or a vertical symmetry guide if you want a perfectly front-facing face. Most artists turn symmetry off before the final pass, since slightly asymmetrical eyes look more natural.
Step 1: Block In the Face Guide
Eye placement determines whether the result reads as anime or as something unsettling, so start there.
- Draw a circle on a new layer, then add a vertical center line and a horizontal line through the middle.
- In the lower half, the eye line usually sits close to that horizontal midline. Anime styles often push eyes slightly lower than realistic proportions, which exaggerates the forehead and gives a younger look.
- Leave about one eye-width between the eyes as a starting rule, then adjust to taste. Wider spacing reads as softer or more innocent. Tighter spacing reads as sharper.
- Mark a rough brow line above each eye.
Drop the opacity of this guide layer and lock it. You will draw on layers above it.
Step 2: Draw the Eye Shape
On a new layer, sketch the upper eyelid as a confident curve. In most anime styles this is the heaviest line in the whole eye.
- Upper lash line: Draw a smooth arc that peaks slightly toward the inner or center third, depending on the look. Thicken it toward the outer corner and add a small flick if you want a stylized lash.
- Lower lash line: Keep this thin and shallow. A light, short curve is enough. Heavy lower lines tend to make the eye look tired.
- Inner corner: Many styles use a small angle or a tiny tear-duct mark here. Keep it minimal.
Use StreamLine in the brush settings, or increase it for your inking brush, to smooth shaky strokes. If a curve is wrong, undo and redraw it in one motion rather than patching it.
Step 3: Build the Iris and Pupil
Create a new layer beneath the lash line layer for the iris.
- Draw a tall oval or rounded rectangle. Anime irises are typically taller than they are wide, and the upper lid often clips the top of the shape.
- Fill it with a mid-tone base color. Use ColorDrop, or draw the shape and fill it with a flat brush.
- Add a pupil as a darker vertical oval in the center. Keep the pupil on its own layer so that you can later scale it or shift it for different expressions.
- Place the iris so that the upper lid overlaps it. A fully exposed iris with white all around reads as startled, which is useful for some expressions but wrong as a default.
Put the eye white (sclera) on its own layer under the iris. Fill it with a very light tint rather than pure white. A slightly warm or cool off-white sits better in most color palettes.
Step 4: Shade the Iris With Clipping Masks
This is where Procreate's layer tools do the heavy lifting.
- Create a new layer above the iris layer and choose Clipping Mask. Anything you paint will stay inside the iris shape.
- With a soft airbrush, paint a darker version of the iris color across the top, fading downward. This simulates the shadow the upper lid casts.
- On another clipped layer, paint a lighter, more saturated tone along the bottom. A slight glow at the lower edge gives the eye depth.
- Add a thin darker ring around the outer edge of the iris on another clipped layer if you want a more defined look.
- Set one of the layers to Multiply for shadows and another to Add or Screen for glow, then lower opacity to taste.
Keeping each effect on its own clipped layer means you can recolor the eye later by adjusting just the base layer. That is far easier than repainting.
Step 5: Add Highlights
Highlights give anime eyes their life.
- Draw a large highlight, usually a rounded shape in the upper portion of the iris, on a new layer above everything else in the eye.
- Add a smaller secondary highlight on the opposite side, in the lower part.
- Keep highlights consistent between both eyes. They should suggest the same light source, so both usually sit on the same side relative to the face.
- For a glossy look, add a few tiny sparkle dots. Resist adding too many. Two or three read as intentional.
Use pure white or a very light tint. If the highlights look flat, lightly soften one edge with the Smudge tool or erase a small section to introduce variation.
Step 6: Finish With Line Art, Lashes, and Brows
Make a new layer at the top for final line work.
- Trace over the sketch with your inking brush. Vary pressure so the upper lash line is thick and tapers at the ends.
- Add two or three individual lashes at the outer corner, curved away from the eye.
- Draw the brow as a separate layer so that you can move or reshape it independently.
- Hide the sketch and guide layers and check the result at 100% zoom.
If the line art looks stiff, reduce the brush's size jitter and let pressure control the taper instead.
Common Mistakes to Avoid
- Flat, evenly weighted lines: Without thick-to-thin variation, the eye looks mechanical.
- Everything on one layer: You lose the ability to change expression, recolor, or animate.
- Mismatched highlights: Different highlight positions in each eye create an unintentional wall-eyed look.
- Overcomplicated detail: More gradients and shapes do not make a better eye. Start simple, then add a layer of detail only when the base reads clearly.
- Ignoring the face: An excellent eye on a poorly placed guide still looks wrong. Check placement first.
Taking Procreate Eyes Into a Motion Pipeline
For motion designers and animators, a drawn eye is often the start of a sequence rather than a final image. A few habits make the handoff cleaner.
- Name your layers: Sclera, iris, pupil, shading, highlights, upper lash, lower lash, brow. Clear names make the layers easier to rig when you open the file in an animation tool.
- Export a layered file: Export in a layered format such as PSD and test that the layers stay intact when you open it in After Effects. You can then animate pupil movement, highlight shifts, and lid position separately.
- Draw expression keys: Create open, half-closed, closed, surprised, and narrowed versions of the eye on separate layers or in separate files. These become your key poses.
- Consider Procreate's animation features: Procreate offers built-in animation options that can work for short hand-drawn loops. For production pipelines, many artists still bring the layers into After Effects for timing and compositing.
Where Styleframe Fits
Hand-drawn key poses are where may be useful, as an AI video and motion tool. Your own drawings can serve as reference material, so the eyes you drew stay the source of truth.
Some practical ways this might work for an anime-eye workflow:
- Keyframe-driven motion: Use your open-eye and closed-eye drawings as keyframes and review any generated in-between motion against your intended timing.
- Style consistency: Check whether reference-driven style tools can push a frame or short clip toward the line weight, color treatment, and shading of your Procreate eye drawing, which helps keep a consistent look across shots.
Whatever tool you use, confirm its supported export formats and resolutions so it fits into your existing pipeline instead of replacing it, and keep your compositing and finishing workflow intact.
Practice Routine for Better Anime Eyes
- Draw the same eye ten times with different iris shapes and highlight placements. Compare which reads best.
- Change only the upper lash line and see how much the mood shifts.
- Draw one eye in five expressions using the same layer structure.
- Flip the canvas horizontally every so often to catch asymmetry.
- Study frames from shows you admire, paying attention to which details they leave out.
Final Thoughts
Anime eyes in Procreate come down to correct placement, a heavy upper lash line, a layered iris, and disciplined highlights. Keep every element on its own layer and the same drawing can support recoloring, expression changes, and animation. For motion work, that structure carries into After Effects, and tools like Styleframe may help extend your keyframes into motion while keeping the art in your hands.